solutions / MEP Services
Coordinated Mechanical, Electrical, and Plumbing Engineering from Design Through Commissioning
Designing and executing these three disciplines under a single coordinated engineering scope eliminates the spatial conflicts, system interface gaps, and commissioning delays that occur when MEP contractors work from independent design packages
Electrical Engineering
LV and MV electrical systems designed to IE Rules, IS 732, and BIS standards, covering power distribution, protection, earthing, and energy management
- HT and LT substation design, equipment selection, and installation supervision
- HT and LT cable sizing, cable tray routing, and containment layout drawings
- Online double-conversion UPS systems, static bypass, and battery sizing calculations
- LT switchboard, MCC, SMDB, and PDB design: fault level calculations and protection coordination
- Interior and exterior lighting design: lux level calculations to IS 3646, emergency lighting to NBC 2016
- Earthing systems to IS 3043, lightning protection to IS 2309, and SPD coordination
Mechanical Engineering
Mechanical building services covering chilled water distribution, compressed air, pressurisation, and utility pipework for commercial, institutional, healthcare, and industrial environments.
- Chilled water pipework design: pipe sizing, pressure drop calculations, and insulation specification
- Building pressurisation and smoke management systems to NBC 2016 Part 4
- Medical gas systems for healthcare environments: oxygen, nitrous oxide, and vacuum
- Primary-secondary and variable primary chilled water distribution systems
- Compressed air generation, distribution, and end-of-line equipment systems
- Industrial process pipework: steam, condensate, and chemical service pipework
Plumbing, Drainage, and Water Supply
Potable water supply, sanitary drainage, and stormwater systems designed to IS 1172, IS 5329, and CPWD plumbing specifications
- Cold water distribution design: storage, pressure boosting, and distribution network sizing
- Sanitary above-ground drainage: trap and stack sizing, vent design, and access provision
- Stormwater management: roof drainage sizing, external network, and soakaway or attenuation design
- Hot water supply systems: central plant, heat exchanger, and distribution with recirculation
- Below-ground drainage: sewer network design, manhole scheduling, and invert level coordination
- Water conservation: low-flow fixture specification, sub-metering, and greywater recycling integration
Key Benefits
- BIM-based coordination eliminates construction-phase spatial clashes and reduces RFI volumes on site
- All designs comply with IE Rules, IS codes, NBC 2016, and CPWD specifications
- Single MEP design authority eliminates interface disputes between separate mechanical, electrical, and plumbing consultants
- Full handover documentation package: as-built drawings, O&M manuals, commissioning records, and statutory certificates